Steinberg CMC Series User Manual

CMC-PD
CMC Series Operation Manual 18
Selecting the bank
To select the bank, use one of the following methods:
• Press [SHIFT] so that the current bank lights.
Simultaneously press [SHIFT] and the number pad
corresponding to the desired bank.
• Simultaneously press [SHIFT] and [CURVE SETUP]/
[4VEL MODE] to move the bank selection up and
down.
• Click on a bank in the CMC-PD Editor window.
NOTE
• The bank information currently set is saved in each
mode so that the next time the device starts with the
saved condition.
• To edit banks, use the CMC-PD Editor.
• For details about the CMC-PD Editor operation, see
“CMC-PD Editor” on page 21.
Changing the velocity curve
In the normal mode, response of output velocity when
pressing the pad can be adjusted by changing the
velocity curve set for the pad. Fixed velocity can also be
selected.
NOTE
The setting of velocity curve applies to all pads of the
entire bank.
To select the velocity curve, use one of the following
methods:
• Press [CURVE SETUP] so that the pad of the velocity
curve number currently selected lights. Then, while
holding down [CURVE SETUP], press the number pad
corresponding to the desired velocity curve.
• Click on a velocity curve in the CMC-PD Editor window.
In this condition, you can check the response of the
selected velocity curve by ear when operating the
device’s built-in pad.
Velocity curve types
The following 16 types are available.
15 C 2
16 G 2
No Name Functions
1 Normal (B)
Pad number MIDI note number
2A
3A Hard
4C
5C Hard
6S
7 S Reverse
84 Step
916
10 32
11 48
No Name Functions

Steinberg CMC Series Specifications

General

Brand	Steinberg
Model	CMC Series
Category	Controller
Language	English