Steinberg HALion Sonic 2 - Page 160

160
Global Effects
HALion 3 Legacy Effects
Stereo Delay
A stereo-in/stereo out delay.
Long Delay
The Long Delay provides the same parameters set as the Delay, except delays up to
four seconds can be set.
Tape Delay
Simulation of a vintage 4-head analog tape delay.
Chorus
A straightforward chorus effect that can be used to “widen” sounds.
Balance Ratio of left delay time to right delay time.
HF Damp High-cut filter to soften delay repeats.
Parameter Description
Parameter Description
Delay Delay time. If the Sync parameter is set to On, the delay time is
set by using various note values.
Feedback Feedback controls the number of delay repeats. For minimum
feedback set the slider to the mid position. By moving the slider
to the left or right “cross delay” is applied, where left output
feeds back into right input or vice versa.
Sync On/Off By activating Sync, delay repeats are synced to the tempo set
in your host application.
Balance Ratio of left delay time to right delay time.
HF Damp High-cut filter to soften delay repeats.
Parameter Description
Delay Delay time. If the Sync parameter is set to On, the delay time is
set by using various note values.
Sync On/Off By activating Sync, the delay repeats are synced to the tempo
set in your host application.
Feedback Feedback controls the number of delay repeats.
Vintage Amount of vintage “color” and tape flutter.
Head 1 Delay level 1 (output is panned left).
Head 2 Delay level 2 (output is panned right).
Head 3 Delay level 3.
Head 4 Delay level 4.
Pan 3+4 Varies the panning of delays 3 & 4 from center to hard left/right.
Vol 3+4 Varies the volume of delay outputs 3 & 4.
Parameter Description
Rate Modulation rate.
Depth Amount of pitch modulation.