176
The Performance Section
The Trigger Pads
3. When you trigger the pad, it switches to the variations that were selected when
you made the snapshot.
For FlexPhraser variations, this includes the FlexPhrasers of all four layers and the
program.
Ö The trigger pad stores which variations were selected when you made the snapshot.
This allows you to change settings of variations even after you made the snapshot.
Ö When layers are replaced or added, you must create a new variation snapshot.
Otherwise, the trigger pads will not switch the variations for these particular layers.
To clear the FlexPhraser snapshot:
1. Right-click the respective trigger pad.
2. Select “Clear FlexPhrasers”.
Bypassing the Pads Section
You can bypass the whole pads section. This deactivates any functionality you
assigned to the trigger pads.
• To bypass the pads section, press the Bypass Pads button to the right of the
trigger pads.
The bypass button lights up to indicate that the trigger pads have been
deactivated.
Using Pad Presets
Presets for the trigger pads can be loaded and saved using the controls in the top left
of the pads section.
• To load a preset, click the down arrow button and select the preset from the pop-
up menu.
• To delete the selected preset from your system, click the trash icon.
You will be asked to confirm the deletion.
• To save a new preset, click the disk icon. A file dialog opens where you can name
and save your preset file.
Ö Pad presets save trigger notes and chord snapshots, but not FlexPhraser snapshots.
This way, you can exchange trigger notes and chords by loading presets without
loosing your FlexPhraser snapshots.
To Next Page
Loading...