STEPCRAFT M.1000 - Pre-Operation Checks and Operator Training

19
Item
Item number
Picture
T-slot table 90°
11987 M.500
11988 M.700
11989 M.1000
Clamping Set M6 10063
Switch-Box 10101
Switch Unit SE 2300 for exter-
nal consumers
10052
Tool Length Sensor TS-32 10103
7. Operation
Commissioning and safe Operation
The machine and all connected components have to be wired correctly and be in perfect condition.
The operator must have completely read and understood the entire documentation of the M-Series
and corresponding instructions. Furthermore, he must have been trained in operating the machine as
well as its accessories and has to be familiar with the use of CNC gantry milling systems and CNC
software.
The workplace needs to be compliant with the applicable regulations and provisions of the respective
industry.