9
Emergency Stop Switch
The emergency stop is located in a separate housing with a magnetic disk and is firmly connected with
the machine. In order to be able to intervene at all times, the emergency stop has to be positioned at a
suitable place.
By pressing the emergency stop switch, the emergency stop is triggered. The control is interrupted.
Additionally, the control software receives the signal to stop the operating process. The machine stops
immediately.
ATTENTION! The emergency stop switch can only effect the stop of all components if these compo-
nents are electronically connected with the emergency stop switch.
If you want to use a system-guided tool, such as a milling and drilling motor, that features a separate
ON / OFF switch and that is NOT controlled via the PC, you have to make sure that it is expertly con-
nected with the emergency stop switch, for example by use of the Switch Unit SE2300 for electric con-
sumers (Item no. 10052). If you do not comply with these requirements, the system-guided tool will
continue to run although you have activated the emergency stop switch leading to a high risk of per-
sonal injury and damage to property!
If you have any questions, please do not hesitate to contact us!
Residual Risk
Despite all safety precautions against the contact with rotating or hot tools and the protection from
crushes, a residual risk remains due to a careless handling and automatic movements of the CNC
system.
Safety Symbols
Symbol: Read manual Alerts user to read manual BEFORE first commissioning
Symbol: Wear ear protection Alerts user to wear a hearing protector
Symbol: Wear safety glasses Alerts user to wear protective glasses
Grounding symbol Alerts user to ground the laser tool / electrical system
General warning symbol Alerts user to warning messages
To Next Page
Loading...
