WORKSHOP MANUAL
TITAN
Chapter
1 - General instructions
EDITION
2018
Page
4
1.3
Guarantee
1.3.1
Exceptions
The guarantee does not cover damage
due to:
•
Failure by users to acquaint themselves
with accompanying documentation.
•
Carelessness.
•
Incorrect and non-permitted use or
assembly.
•
The use of non-genuine spare parts.
•
The use of accessories not supplied or
approved by Stiga.
Neither does the guarantee cover:
•
Wear components such as blades,
belts, wheels, battery and cables.
•
Normal wear.
•
Engine and transmission. These are
covered by the engine manufacturer’s
guarantees, with separate terms and
conditions.
The purchaser is covered by the national
laws of each country. The legal rights of
the purchaser laws are not restricted by
this guarantee.
1.3.2
Conditions of the guarantee
The guarantee card must be filled in with
all information and then sent to Stiga or to
the Stiga dealership.
In the event of a claim a record of previ-
ous services must be shown by a copy of
the service book.
1.2.6
Tightening torques
Unless otherwise stated, the tightening
torques given in section 1.7.1 apply to the
relevant screw. This does not apply to
self-tapping screws, which are mainly
used for assembling body components.
1.2.7
Sharp edges
Look out for sharp edge’s, es’pecially
when working with the cutting deck. The
blades can be extremely sharp. Always
use gloves when working with the blades.
1.2.8
Spare parts
Always use genuine spare parts for re-
pairs.
1.2.9
Check
Each component that is removed in con-
junction with service, must be checked
for damage.
Look out for: wear, cracks, out of shape,
straightness, pitting, discolouration,
noise and jamming.
To Next Page
Loading...
Need help?
General
