Stihl 4180 Series Service Manual

Series 4180 Powerhead 33
N Push lever (9) into the throttle trigger (11) as far as
stop so that the hooked end of the torsion spring (10)
projects from the opening (arrow).
N Attach the throttle cable (14).
N Fit the throttle trigger (11) with lever (9) in position so
that the hooked leg of the torsion spring (10) engages
the pivot.
N Depress the lockout lever (8) and fit the throttle trigger
(11) so that it engages the lockout lever (8).
N Press sleeve of throttle cable (14) into the guide
(arrow).
N Press protective hose of throttle cable (14) into the
guide (arrow).
N Fit the ‘outer handle molding’ (18).
N Insert and tighten down the screws (12).
N Fit short-circuit wire, ground wire and throttle cable on
the engine, @ 8.11.
N Install the control handle, @ 12.2.
10 11
9
0000-GXX-2477-A0
814
11 10
9
9
0000-GXX-2478-A0
14
0000-GXX-1919-A0

Stihl 4180 Series Specifications

General

Brand	Stihl
Model	4180 Series
Category	Engine
Language	English