Stihl FS 240 - Drive Tube Assembly with Control Handle for Bike Handle; The Drive Tube; Assembly with a

113FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
: Orient drive tube assembly (1)
and tighten screw (2) through the
opening (arrow)
– Drive tube assembly is
clamped and secured
The sticker on the drive tube
assembly must be visible when
using the machine.
: Insert protective tube (1) in the
guide (arrows) and install cable
holder (2)
: Orient control handle for loop
handle (1) so that the trigger
interlock (2) faces up
5904RA446 TG
1
2
5904RA447 TG
1
2
5904RA448 TG
1 2
3 3
: Tighten screws (3)
– Control handle for loop handle
is clamped and secured
– Check instruction label on drive
tube assembly for damage and
legibility, replace if necessary
12.2 Drive tube assembly with
control handle for bike
handle
– Remove control handle for bike
handle and remove protective
tube from guides. b 10.2
: Undo the screw (1)
: Pull the drive tube assembly (2)
out of the clutch housing
Versions with antivibration
housing
: Undo the screw (1)
5904RA388 TG
1
2
5904RA224 TG
1
2
: Pull drive tube assembly with
antivibration housing (2) out of
the clutch housing
– Examine the drive tube
assembly, repair or replace if
necessary, b 12.2.2
With a new drive tube assembly, the
installed parts or components must
be converted.
Installation
– Degrease clamping area,
b 14
Throttle cable support and carrying
ring must be installed, b 12.3.4,
b 12.3.3.
: Orient end of drive tube
assembly with stopper
installed (4) so that it faces the
engine
: Push the drive tube assembly (1)
through the cover (2) in the clutch
housing with gentle twisting
motions until the square
profile (3) of the drive shaft
engages the clutch drum, if
necessary, turn the square profile
of the drive shaft or the drive shaft
at the gearbox on the opposite
end
– The drive tube assembly must be
seated in the clamp as far as it
will go.
5904RA389 TG
1
2
3
4