Name: Stihl MS 194 T
Brand: Stihl
Rating: 5 (1 reviews)

To Next Page

To Previous Page

MS 194 T

English

Mounting the guide bar

N Turn the screw (7)

counterclockwise until the tensioner

slide (8) butts against the left end of

the housing slot.

N Fit the guide bar over the stud (9)

and engage the peg of the tensioner

slide in the hole (10).

Fitting the Chain

WARNING

Wear work gloves to protect your hands

from the sharp cutters.

N Fit chain around the sprocket (11)

and over the guide bar – the cutting

edges on top of the bar must point to

the bar nose.

N Turn the screw (7) clockwise until

there is very little chain sag on the

underside of the bar – and the drive

link tangs are engaged in the bar

groove.

N Refit the chain sprocket cover –

the pivot pin on the hand guard must

engage the sleeve – and then screw

the nut onto the stud finger-tight.

N Go to chapter on "Tensioning the

Saw Chain"

142BA059 KN

142BA060 KN

142BA061 KN

142BA062 KN

Questions and Answers:

Need help?

Do you have a question about the Stihl MS 194 T and is the answer not in the manual?

Stihl MS 194 T Specifications

General