0478-131-3050-A
58
English
15 Settings
– Reset lock: The PIN code must be entered prior to
resetting the machine to the factory defaults.
– Medium:
– All of the features from the "Low" setting.
– Time lock: PIN code query for changing a setting if no
PIN code has been entered for more than one month.
– High:
– All of the features from the "Medium" setting.
– Setting protection: The PIN code must be entered
before settings can be changed.
► Select the desired security level and confirm it by pressing
the OK button.
► If necessary, enter the 4-digit PIN code.
STIHL recommends that the "Low," "Medium" or "High"
security level be set as part of the installation process.
GPS protection
For theft detection, STIHL recommends activating the GPS
protection feature.
Change PIN code
► Enter the old PIN code and confirm it by pressing the OK
button.
► Enter the new 4-digit PIN code and confirm it by pressing
the OK button.
Take note of your PIN code and keep it in a safe place. If the
PIN code is entered incorrectly 5 times, automatic operation
is switched off and can only be restored with a master code
generated by your authorized STIHL iMow servicing dealer.
Start signal
Alarm signal
Menu signal
Child lock
If the impact sensor is triggered several times in succession
within a short time, the robotic mower and the mowing blade
will stop.
If the impact sensor is not triggered again, the robotic mower
will continue automatic mowing after a few seconds.
Keylock
Link iMow and dock:
► Install the docking station and connect the perimeter wire,
@ 10.3 and @ 10.5.
To activate the GPS protection feature.
The 4-digit PIN code can be changed if necessary.
The "Change PIN code" menu item is only displayed
in the "Low," "Medium" or "High" settings.
The acoustic signal when the mowing blade is
activated.
The acoustic signal when the robotic mower hits an
obstacle.
The acoustic indicator when you open a menu and
confirm a selection by pressing the OK button.
When the keylock is activated, the control panel is
locked. The operator must press and hold the Back
button and then press the forward navigation button
on the navigation pad to unlock the control panel. The
keylock will lock the control panel again 2 minutes
after the last button is pressed.
The mower and docking station must be linked if you
replace the docking station or the robotic mower.
1
0000-GXX-4398-A2
To Next Page
Loading...
