0478-131-3050-A
31
English
10 Installing the Robotic Mower
10.6 Linking the Robotic Mower and Docking Station
The robotic mower can only be operated if it receives the
wire signal emitted by the docking station. The robotic
mower and docking station must be linked before the mower
can receive the wire signal.
Checking the wire signal may take several minutes.
► To terminate the linking process, push the STOP button.
The previous step of the installation assistant will be
called up again.
► Continue the initial installation by pressing the OK button
on the control panel.
Interrupted Reception
If the wire signal is interrupted or not received properly, the
display will show one of the following symbols:
For troubleshooting information, @ 22.2.
10.7 Checking the Installation
► Start the test run by pressing the OK button on the control
panel. This does not activate the mowing blade.
► Close the flap.
The robotic mower will start following the perimeter wire
along the edge of the mowing area.
► As the robotic mower follows the edge, walk behind it and
ensure the following:
– The robotic mower follows the edge of the mowing area.
– The robotic mower clears obstacles and the borders of
the mowing area.
Once the robotic mower and the docking station
are linked properly, the display shows this
symbol and the message "Wire signal OK".
The robotic mower is not receiving a wire signal.
The display shows the message "No wire
signal."
The robotic mower is receiving a faulty wire
signal. The display shows the message "Check
wire signal."
The robotic mower is receiving a reversed-
polarity wire signal. The display shows the
message "Connections swapped or iMow
outside."
To Next Page
Loading...
