0478-131-3050-A
30
English
10 Installing the Robotic Mower
► Close the cover of the cable duct (10).
► Check the routing of the perimeter wire. The two perimeter
wire ends must be routed as illustrated.
► Press the OK button on the control panel.
► Re-attach the cover as described in the "Installing the
docking station" section (@ 10.3) and press the OK
button on the control panel.
► Connect the power supply plug to the electrical outlet and
press the OK button on the control panel.
When the perimeter wire is correctly installed and connected
to the docking station, a glowing red LED (11) will indicate
that the docking stations is ready for operation.
► If the LED flashes red or remains off, the perimeter wire is
broken or not correctly connected to the docking station. It
could also indicate a malfunction in the docking station.
Check the perimeter wire or contact a STIHL iMow
servicing dealer.
► Lift the robotic mower slightly by the rear carrying
handle (12) and relieve the weight on the drive wheels.
► Push the machine, resting on its front wheels, into the
docking station.
► Press the OK button on the control panel.
10
0000-GXX-5355-A0
0000-GXX-5413-A2
perimeter wire
0000-GXX-3363-A2
Plug in the
docking station
To Next Page
Loading...
