33TS 400
English / USA
When the engine has turned over
for the first time:
: Move the choke lever (4) to e
: Press the button of the
decompression valve (5) again
before each fresh attempt to start
the engine.
: As soon as the engine is running,
briefly blip the throttle trigger, the
control lever (3) returns to its normal
position # and the engine idles.
If the carburetor has been set
correctly, the abrasive wheel must
not turn when the engine idles.
The cut-off machine is now ready for
use.
To switch off the engine:
: Move the control lever (3) to "0" c
If the temperature is very low,
let the engine warm up.
: Briefly blip the throttle trigger when
the engine has started =
disengage starting throttle position.
The control lever reverts to its
normal position # and the engine
idles.
: Gently press the throttle trigger and
let the engine warm up.
If the engine refuses to start:
The choke lever was not returned to its
warm start position = e when the
engine turned over for the first time and
it has now been flooded.
: Disconnect the spark plug
terminal (1).
: Unscrew and dry the spark plug.
: Set the control lever to "0" c
: Press the throttle trigger in
completely.
: Pull the starter rope through several
times to vent the combustion
chamber.
: Replace the spark plug and
reconnect the spark plug terminal.
4
Choke
338BA017 KN
5
3
START
338BA018 KN
START
STOP
3
338BA019 KN
START
1
338BA020 KN
To Next Page
Loading...
