Stihl TS 400 Cutquick - Troubleshooting Cutting Wheel Issues; Common Wheel Problems and Remedies

23TS 400
English / USA
Troubleshooting
Cutting wheel
1)
STIHL recommends that a STIHL
servicing dealer be consulted.
Problem Cause Remedy
Frayed edges or tears, cut wanders out
of line, increased wear at the sides of the
segments
Radial or axial run-out Consult a dealer
1)
Cutting wheel wobbles Use a new cutting wheel
Frayed edges, cut wanders out of line,
little or no cutting performance, sparking
Cutting wheel is blunt; built-up edges on
cutting wheels for stone
Dress the cutting wheel for stone by
briefly cutting in abrasive material; use a
new cutting wheel for cutting asphalt
Poor cutting performance, high level of
segment wear
Cutting wheel rotates in the wrong direction Mount the cutting wheel with correct
direction of rotation
Chipping or cracking in the wheel core
and segments
Overload Replace immediately with a new cutting
wheel
Undercutting Cutting in a material for which the wheel is
not rated
Use a new cutting wheel; note the
different cutting layers in different
materials