Stihl TS 400 Cutquick User Manual

46
English / USA
TS 400
EPA / CEPA:
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category:
A = 300 hours,
B = 125 hours,
C = 50 hours
CARB:
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours,
Intermediate = 125 hours,
Moderate = 50 hours
Engine
STIHL single cylinder two-stroke engine
Ignition System
Type: Electronic magneto ignition
Spark plug (suppressed):
Bosch WSR 6 F or NGK BPMR 7 A
Electrode gap
0.02 in (0,5 mm)
Carburetor
All position diaphragm carburetor with
integral fuel pump
Starter system
ElastoStart starter rope
dia. 0.18 in (4.5 mm)
1122 190 2900
Fuel tank capacity
1.39 pt (0,66 l)
Abrasive wheels
Composite abrasive wheels for steel,
stone, asphalt, ductile cast pipes and
plastics
1)
.
Diamond abrasive wheels for stone and
asphalt.
Dia. 12 in (300 mm) or 14 in (350 mm)
0.10 to 0.24 in (2.6 to 6 mm) thick
Arbor hole diameter, spindle
diameter
0.787 in (20 mm)
Min. thrust washer diameter
4.1 in (103 mm)
Cutting depth with thrust plate
dia. 4.1 in (103 mm):
3.9 in (98,5 mm) for dia. 12 in (300 mm)
4.9 in (123,5 mm) for dia. 14 in (350 mm)
1)
Not available in all countries
Specifications
Displacement: 3.9 cu.in
(64,1 cm
3
)
Bore: 1.93 in
(49 mm)
Stroke: 1.34 in
(34 mm)
Maximum spindle speed:
(make sure that the
maximum operating
wheel speed is above or
equal to the maximum
spindle speed of your
cut-off machine)
5350 rpm

Stihl TS 400 Cutquick Specifications

General

Power Output	3.2 kW
Weight	9.6 kg
Fuel Tank Capacity	0.71 l
Cutting Wheel Diameter	300 mm
Wheel Size	12 in.
Blade Diameter	300 mm
Engine Type	Two-stroke gasoline engine