41TS 400
English / USA
: Fit a new spring housing with the
bottom upwards and guide the outer
spring loop round the lug
: Refit the rope rotor
: Tension the rewind spring
: Refit the fan housing and screw it
into place
If the spring has popped out of the
spring housing:
: Replace it, working anticlockwise
from the outside inwards
: The arrow on the tensioning nut (1)
must point to "0".
: Turn the tensioning nut approx.
1/4 turn anticlockwise as far as the
stop = "0" with the combination
wrench.
: Unscrew the hexagon bolts (2)
: Remove the V-belt guard and
bearing with guard
: Undo the screws (3) in the starter
cover
: Remove the starter cover
: Remove the defective V-belt form
the cast arm
: Carefully insert the new V-belt in the
cast arm and in the V-belt pulley on
the engine
: Fit the starter cover
: Hold the bearing with guard against
the cast arm
: Insert the V-belt in the V-belt
pulley (5)
: Line up the threaded bores in the
bearing plate with the slots in the
cast arm
: Fit the V-belt guard
: Screw in the hexagon bolts (2) as
far as the stop, but do not tighten
them yet
Continue as described in the
chapter "Tensioning the V-belt".
338BA033 KN
Replacing the V-belt
3
3
1
2
3
4
338BA047 KN
338BA035
5
2
To Next Page
Loading...
