STIHL TS 400 12
3.5 Clamp
•
- Remove starter cover,
see chapter 3.3.
• Turn hexagon on clamp clockwise
until the internal helical spring is
completely detensioned.
• Remove the clamping lever from the
housing slot.
The parts are installed in reverse
order.
Insert both parts together. Tighten
the fastening nuts with a torque of
4.5 Nm.
• Remove the clamp. Insert the hook of the draw bar
into the bore.
• Unscrew the fastening screws of
the clamp.
Note: The clamp must be
assembled if necessary.
To Next Page
Loading...
