Stihl TS 400 - Crankcase; Removing the Crankshaft

STIHL TS 400 23
5.9 Crankcase
5.9.1 Removing the crankshaft
- Remove clutch, see chapter 4.1.
- Remove flywheel, see chapter 6.5.
- Remove cylinder and piston,
see chapter 5.6.1.
• Draw impulse hose off connector.
• Unscrew the screws in the
rubber buffers.
- Remove crankcase.
• Insert three M5x72 screws into the
holes marked "13" and screw them
in until they rest against the drilled
plate.
• Unscrew the screws from the
cast arm.
• Unscrew the screws in the two
halves of the housing.
Note: Assembly devices without the
holes marked "13" can be modified
as illustrated.
The drilled plate is viewed from
below in the diagram.
• Prise stoppers out of the rubber
buffers on the ignition side.
- Partly unscrew the spindle of
assembly tool ZS.
Note: The spindle has a left-hand
thread.
- Hold assembly tool ZS against
the clutch-side half of the housing
so that the notch marked "3" is at
the bottom.