Stihl TS 400 - Flywheel

STIHL TS 400 32
6.5 Flywheel
• Draw out the ground lead (2).
Note: Slide the tab (1) under the
housing and press the retainer (2)
down until the sloping edge (3)
engages in the slot (4).
• Insert locking strip (1) in the
cylinder with the lateral tabs
pointing outwards to block the
crankshaft.
• Unscrew the screw (1) in the
cover.
Note: Unscrew the other two
screws too.
Removing the flywheel:
• Press the cap in at the bottom,
slide it upwards and remove it.
• Press catch (1) down and draw
contact sleeve (2) of stop switch
lead out of the mount for retainer
Ground wire, contact spring:
- Draw contact sleeve of ground
wire out of the mount for the
contact spring.
• Press contact spring retainer out of
slot and remove it.
- Press contact spring out of retainer.
Reassemble parts in reverse order.
• Disconnect spark plug terminal (1)
from spark plug (2).
- Unscrew spark plug.