Stihl TS 400 - Operating Instructions and Wheel Guard

STIHL TS 400 13
5. ENGINE
5.1 Muffler
Refer to the manual
"Troubleshooting, standard
repairs" for troubleshooting
procedures.
Note: The spark arresting screen
can also be replaced without
removing the muffler.
- Remove bearing with guard,
see chapter 3.1.
4. CLUTCH
4.1 Removal and installation
Refer to the manual "Troubleshootings,
standard repairs" for troubleshooting
procedures.
- Remove V-belt, see chapter 3.4.
• Unscrew clutch and attachment
from the crankshaft.
Important! The clutch has a
left-hand thread.
- Remove the cover washer from
the crankshaft stub.
- Dismantle and reassemble
clutch; see manual "Trouble-
shooting, standard repairs".
• Screw on clutch and tighten to
40 Nm with insert (1).
- Attach V-belt pulley,
see chapter 3.4.
• Unscrew the muffler screws.
• Remove muffler.
• Slip on cover washer with the
word "TOP" pointing outwards.