Stihl TS 400 - Leaf Spring; Rod; Handle

STIHL TS 400 38
9.4 Handle9.3 Rod9.2 Leaf spring
- Unscrew spark plug, see 6.5.
- Remove slide control, see 9.1.
• Press the leaf spring down until
the short part (1) is located below
the tab (2).
• Remove torsion spring from rod.
The rod is installed in reverse
order.
• Unscrew the screws (1) in
support (2).
• Remove support and handle (3).
- Remove shroud, see 5.5.
• Unscrew the screw (1) on
retainer (2).
- Remove retainer with rod.
• Unscrew the screws from the
handle mount.
• Press spring leaf (1) together at
bottom and draw it out to the top.
• Press retainer (1) off rod (2). • Unscrew the lower screws.