Stihl TS 400 - Page 27

STIHL TS 400 27
Note: Remove the protruding housing
gasket on the assembly face for the
cylinder.
- Coat the sealing lips of the rotary
shaft seals with grease,
see chapter 11.2.
• Slide assembly sleeve (1) over
the clutch-side crankshaft stub.
• Screw in the screws and
alternately tighten them cross-
wise with a torque of 10.0 Nm.
• Hold the crankshaft and remove the
assembly tool by turning the spindel
counterclockwise.
- Unscrew the M5x72 screws fitted to
prevent twisting.
- Slide the rotary shaft seal over
the assembly sleeve with the
open side facing the crankcase.
• Drive in with press sleeve (1).
- Remove the assembly sleeve
after pressing in the rotary shaft
seal.
- Wait approx. one minute and
then turn the crankshaft over
several times.
The remaining parts are
reassembled in reverse order.
Note: The screws of the cast arm
must be tightened with a torque of
10.0 Nm and those of the rubber
buffer with 6.0 Nm.
- Slide the rotary shaft seal over
the ignition-side crankshaft stub
with the open side facing the
crankcase.
• Drive in with press sleeve (1).