Still RX70-16 - STILL Safetylight (Variant)

4 Operation
Auxiliary equipment
The upper working spotlights are switched on
by the proximity switch when the fork carriage
reaches or exceeds the preset lift height.
The upper working spotlights are switched off
by the proximity switch when the fork carriage
falls below the preset lift height again.
CAUTION
Possible component damage caused by collision if
the proximity switch is set incorrectly.
– The proximity switch may be adjusted by trained
personnel.
– Inform the relevant service centre.
STILL SafetyLight (variant)
The STILL SafetyLight is a visual warning unit
to enable early detection of trucks in driving
areas with low visibility (such as drive lanes,
high racks), as well as at blind junctions.
The STILL SafetyLight is mounted on a
support on the overhead guard such that
it is not affected by jolts and vibrations. It
projects one or more light blue light spots
approximately 5 meters in front of or behind
the truck and thus warns others about the
approaching truck.
WARNING
Danger of damage to eyes when
looking into the STILL SafetyLight.
Do not look into the STILL SafetyLight.
NOTE
If the truck is to be
operated on public roads,
the STILL SafetyLigh
tmustbeswitchedoff.
216
174749 EN - 03/2017