Operation 4
Testing and activities before dail
yuse
Unit
Component
Course of action
Hydraulics
Lift and tilt cylinders, tank, valve
block, hoses, pipes, connections
Perform a visual inspection for damage
and leaks.
Check the area under the forklift truck
for leaking consumables.
Damaged hoses must be replaced by
the authorised service centre.
Wheels, tyres
Perform a visual inspection for wear
and damage.
Make sure that only rims of the same
type from the same manufacturer are
fitted.
In the event of uneven tyre wear,
replace both tyres.
Observe the safety regulations in the
chapter entitled "Tyres".
Chassis frame
Axle
Make sure that no consumables are
escaping from the axle.
– Do not use the truck if there is any damage
or defects.
– Contact your authorised service centre.
7312_003-080
1
Checking the cooling fluid level
The cooling fluid level is monitored by a
sensor.
As soon as the message
COOLANT LE-
VEL appears on the dis
play, proceed as fol-
lows.
WARNING
Risk of scalding due to hot cooling fluid!
The cooling system is pressurised! Opening the
cooling fluid tank may result in hot cooling fluid
leaking out. Only open the cooling fluid tank when
the cooling system is cool.
– Switch off the engine and let it cool down.
– Do not open the cooling fluid tank until the truck
has cooled down.
WARNING
Coolant and cooling fluid can pose a hazard to
health and the environment!
– Observe the safety regulations set out in the
chapter entitled "Coolant and cooling fluid".
– Check coolant level.
174
749 EN - 03/2017 71
To Next Page
Loading...
