Operation 4
Cleaning
Cleaning
Cleaning the truck
– Park the truck securely.
WARNING
There is a risk of injury due to falling
when climbing onto the truck!
When climbing onto the truck, you
can get stuck or slip on components
and fall. Higher points on the truck
may only be made accessible with
corresponding devices.
– Adhere strictly to the following
steps.
– For climbing onto the truck, use only the
steps provided for this purpose.
– For reaching inaccessible places, use
devices such as stepladders or platforms.
CAUTION
If water penetrates the electrical system, there is a
risk of short circuit!
– Adhere strictly to the following steps.
– Before cleaning, switch the electrical
system off so that there is no voltage.
– Do not spray drive units and electrical
components or their covers directly with
water.
CAUTION
Failure to follow these instructions could result in
damaged components!
The engine must be switched off during washing.
Water should not be used for cleaning the area
around the central electrical system; instead, only
clean with a dry cloth or clean compressed air.
CAUTION
Excessive
water pressure or water and steam that
are too ho
t can damage truck components.
– Adhere st
rictly to the following steps.
–Onlyuseh
igh-pressure cleaners with a
maximum o
utput power of 50 bar and at a
maximum tem
perature of 85°C.
174
749 EN - 03/2017 275
To Next Page
