SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 110 (160)
Appendix B. TFTP Server
TFTPD32 is a freeware TFTP server for Windows 9x/NT/XP PCs (but seems to work on Windows 2000
as well), which is small, and easy to install and use. Use the link below and download the software.
http://tftpd32.jounin.net/
Short installation description:
1. Install the program on a PC located at either the Hub or a local LAN
2. Start the program
3. Select correct server interface if using a PC with more than one Ethernet card.
4. Select correct base directory (directory where the files to be downloaded are stored, and where
uploaded files will be stored)
5. You are up and running with a TFTP server
6. The TFTP server can now be accessed from the STM SatLink VSAT by using the CLI commands
upload and dload.
TFTP upload from and download to the STM SatLink VSAT have been tested with version 3.23 of this
TFTP server, but any TFTP server should work. It is however essential that the TFTP server has support
for negotiation of block lengths up to 8 Kbytes in order to obtain satisfactory performance over the
satellite link, in terms of acceptable download time.
The STM SatLink VSAT can access a TFTP server on both the satellite and the Ethernet interface.
To Next Page
Loading...
