SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 144 (160)
Appendix J. The Boot SW
The STM SatLink VSAT has two SW applications installed:
1) Boot
2) DVB-RCS Application
The Boot SW is stored outside the file system and can be compared with the BIOS and MS-DOS on a PC.
It is used to have access to file system and the LAN when there is no application loaded on the STM
SatLink VSAT.
The Boot SW is always loaded after powering on the STM SatLink VSAT. But normally the user need
not care about the boot SW since the DVB-RCS application is loaded by default.
The boot-loader can only be accessed via RS-232 as described in Appendix A. After power on, an output
similar to this is displayed on the HyperTerminal:
Boot-loader
- SW ID 120044, Revision 14.0.0
File system initialized
Press return to enter boot-loader
In order to logon and use the boot SW, press return (the software will wait 10 seconds before
automatically loading the DVB-RCS application):
1. When
Login is displayed type the user name install
2. When
Password is displayed type dvbrcs
In the boot-loader a minimal CLI is available, supporting the file system commands and access to the
LAN. Type
? (question mark) to display the available CLI commands.
To Next Page
Loading...
