STM SatLink 2000 - S Ummary

SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 38 (160)
events to file, set the minimum severity level of events that shall be logged to file and set the maximum
size for the logfile. By default, Major and Critical events are logged to file.
8.4 CLI Command Summary
The available CLI commands are listed below.
CLI commands Available
in Boot
SW
Available in
Application
SW
User
Privilege
Level
? [sub-menu] [cmd] x x 5
del <filename> x x 2
ren <filename1> <filename2> x x 2
mv <filename1> <filename2> x x 2
dir [ext] x x 5
type <filename> x x 5
dload <filename> <ipaddr> [<localname>] x x 2
upload <filename> <ipaddr> [<remotename>] x x 3
ping
{
<ipaddr> [<options>]
}|
<-enablemonitor
|
-
disablemonitor>
xx 5
exit xx 5
logout x x 5
restart x x 3
save config
arp flush
arp show
x
x
x
3
3
5
device snmp show
x 1
device snmp community <name> <ro|rw>
[<ipaddr> <mask>]
x 1
device snmp delcommunity <name>
x 1
device manager show
x 1
device manager add <func> <if> [<ip> <mask>]
x 1
device manager del <func> <if> [<ip> <mask>]
x 1
device name <name>
x 2
device contact <contact>
x 2
device location <location>
x 2
device show [-dvbs2]
x 5
device telnet show [-session id]
x 5
device telnet disconnect <session id>
x 1
dvb atmmode <mode>
x 2
dvb hdrcomp <mode>
x 2
dvb brx show [-stats]
dvb brx stats [enable | disable]
dvb mesh show [-links| -config| -routes| -
stat]
dvb mesh enable
dvb mesh disable
dvb tx autostart <on
|
off
|
traffic> [<timeout>] x 2
dvb tx calibrate [<freq> [<timeout>]] x 2
dvb tx cw <on
|
off> [-notrack] [<pow> [<freq>
[<timeout>]]]
x 2
dvb tx cwfreq <freq> x 2
dvb tx eirp <eirp> x 2
dvb tx logoff x 3
dvb tx logon x 3
dvb tx outpow <pow> x 2
dvb tx show [-burst
|
-capacity
|
-queue
|
-ts] x 5