STM SatLink 2000 - Page 139

SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 138 (160)
Example:
If the values above have been configured the
ip show command will give the following result.
(Interface 1 is the LAN interface, interface 2 is not used, and interface 3 is the DVB (satellite)
interface):
#
ip show
Interfaces
If IPAddress SubnetMask BroadCastAddr MTU Alias
AdminStatus
1 10.20.42.1 255.255.255.0 10.20.42.255 1500 eth0 1
2 N/A N/A N/A 4074 air0 1
3 10.42.0.42 255.255.255.255 10.42.0.42 4074 dvb0 1
DNS Client Configuration
Primary DNS Server: 213.42.20.20, Secondary DNS Server:
Interface Statistics
------------- Input ----------------- ------------- Output ----------------
If UCast NUCast Disc Octets UCast NUCast Disc Octets
1 4354 7226 6060 831931 103 99 0 18381
2 0 0 0 0 0 0 0 0
3 696 0 0 66518 5038 0 0 389150
IP Receive Deliver Errors Discards Forward Request NoRoute Discards
5797 1379 0 0 4418 805 0 4
Interface Directed Routing Table
In If Out If
Routing Table
DestMask RouteMask NextHop If
0.0.0.0 0.0.0.0 0.0.0.0 3
10.20.42.0 255.255.255.0 0.0.0.0 1
10.42.0.42 255.255.255.255 0.0.0.0 3
4) Save the IP configuration to Flash memory
– Enter the CLI command:
save config
– Example:
# save config
Saving Configuration. This will take ~20 secs
# Configuration Saved
#
If the prompt sign (#) does not show, press <
ENTER>.
H.2 DNS configuration
The DNS server the SatLink VSAT uses is normally configured automatically by the SatLink Hub. For
system where this is not done, the primary, and optionally secondary, DNS server IP addresses can be
configured using the CLI command
ip dns server.
Example: