STM SatLink 2000 - SATLINK VSAT CONFIGURATION AND LINE-UP USING COMMAND LINE INTERFACE

SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 40 (160)
CLI commands Available
in Boot
SW
Available in
Application
SW
User
Privilege
Level
ip dhcp exclude <no> x 3
ip gre add <destaddr> <netmask> <tunnelipaddr>
1
x 2
ip gre del <ifnum>
1
x 2
ip gre show
1
x 5
ip pep disable [httpa]
1
x 2
ip pep enable [redirect|trans|httpa]]
1
x 2
ip pep server <pepsrvipadd>
1
x 2
ip pep show [-cache]ip pep flush -cache
x 5
ip pep bypass <-add|-del|-show|-reset> [<URL>]
1
x 3
ip pep dynbypass <options>
1
x 3
ip pep flush -cache
ip udpsend <options> x 5
ip udprecv <options> x 5
log file <enable
|
disable> [<severity>
[<filesize>]]
x 3
log show [<number>
|
<-all>
|
<-conf>
|
[-file
<number>]
x 5
odu lnb <type> x 2
odu txtype <type> x 2
odu antenna <type> x 2
odu show [-diseqc] x 5
sw license <feature> <key>
x 2
sw mcast <value> [<pid>] [<addr>] [<port>]
x 2
sw upgrade [-default] [<filename>
[<tftp-ip-addr>]]
x 2
sw restore x 2
sw show x 5
user add <username> <passwd> [<userlevel>] x x 4
user del < username> x x 4
user passwd [<oldpasswd>
|
<username>]
<newpasswd>
xx 5
user show xx 5