SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 58 (160)
9.5 Prepare the STM SatLink VSAT for Normal Operation
The connection to the Internet over the satellite network should now be tested and found working. The
only thing left is then the final configuration to prepare the STM SatLink VSAT for normal operation.
The STM SatLink VSAT must be started and you must be logged in as a user with minimum privilege
level 2 (e.g.
install user) before completing the following operations.
1. Configure the STM SatLink VSAT to automatically start the receiver by typing the CLI command
dvb rx autostart on
.
Setting the RX autostart on will ensure that the receiver is started automatically after e.g. power
failure, link failure, Hub restart, or a software failure, etc. without needing user intervention.
Verify that auto start is on for the receiver by typing the CLI command
dvb rx show.
2. Configure the STM SatLink VSAT to automatically start the transmitter by typing the CLI command
dvb tx autostart on
.
Setting the TX autostart on will ensure that the transmitter is started automatically after e.g. power
failure, link failure, Hub restart, or a software failure, etc. without needing user intervention.
Or alternatively follow the procedure in section 13 if the VSAT shall use traffic-initiated logon.
Verify that auto start is on for the transmitter by typing the CLI command
dvb tx show.
3. Save the configuration by typing the CLI command
save config.
To Next Page
Loading...
