SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 98 (160)
the mobile VSAT will simply resume communication with the Hub immediately as assume the outage
was just caused by a short blocking.
The example below disables the optimised tuning for mobile VSATs.
dvb rx tablecache off
It should be noted that the tablecache command is only recommended for use with mobile VSATs as the
standard configuration is optimised for fixed VSATs. Note also that one generally wants to increase the
TunerRetryTime to recover two-way communication faster after a blocking, but setting this parameter too
high will cause longer outages in case of a real outage where forward link re-acquisition might be
required to recover.
To Next Page
Loading...
