STMicroelectronics 32L4R9IDISCOVERY - Appendix E Fanout Board (MB1280); Mikroelektronika Mikrobus Compatible Connector (Fanout CN10; CN11); Figure 36. Stmod+ Fanout Module Plugged into CN1 Connector

DocID030906 Rev 2 71/78
UM2271 Fanout board (MB1280)
77
Appendix E Fanout board (MB1280)
The Fanout board (see Figure 36) is included in the 32L4R9IDISCOVERY kit. It is
connectible to STMod+ connector (CN1) and it provides access to:
• MikroElektronika Click board compatible connectors (CN10 and CN11: two 1x8-pin
female connectors)
• ESP-01 compatible connector (CN4: 2x4-pin female connector)
• Seeed Studio™ Grove compatible connectors (CN3 and CN2: two 1x4-pin male
connectors)
• Reserved standard 2.54 mm pitch of STMod+ pin header for breadboard.
The main active component for this Fanout board is the 3.3 V regulator U1 (200 mA).
Figure 36. STMod+ Fanout module plugged into CN1 connector
E.1 MikroElektronika mikroBUS™ compatible connector
(Fanout CN10 / CN11)
The mikroBUS compatible connector is 2.54 mm pitch with a pair of 1x8-pin female
connectors.
Table 33 shows the definition of the pins.
06Y9
%UHDGERDUGFRQQHFWRUV
PLNUR%86
FRQQHFWRUV
(63
:L)LFRQQHFWRU
*URYH8$57
FRQQHFWRU
670RGIHPDOH
'LVFRYHU\
ERDUG
FRQQHFWRU
9&&VHOHFWLRQ
9E\GHIDXOW
*URYH,

&
FRQQHFWRU
)DQRXW
670RGPDOH
FRQQHFWRU