S800A GNSS Receiver – User Manual 10
module inspection fails, it will voice broadcast current module inspection fail,
keep module led flashing and buzzer sounding until you restart the receiver.
Self-check lasts for about 1 minute. If there is self-check failure, please
contact local dealer.
c) If every module indicator is lit with no flashing, and voice broadcast
says every module work normally (such as “GPS self-check. OK.”), it means all
the modules work normally. Receiver starts to work after the whole self-
check finishes.
2.2 Standard Accessories
2.2.1 Transport container
There are two kinds of S800A containers: Rover container and Base
container. These two containers have similar appearances but their insert
layouts are different. (S800A containers are still under production.)
2.2.2 Adaptor
S800A receiver adopts internal battery. You can use adaptor to charge the
receiver. S800A receiver and handheld share the same adaptor model as
illustrated in Figure 2-12.
To Next Page
Loading...
Need help?
General
