S800A GNSS Receiver – User Manual 18
3.2.2 Start of Base
Open Cube-a on the handheld to choose communication mode. Click
“Device” - “Working mode” to choose base mode and configure its start up
mode, parameters, data link and satellite system and other settings.
Base has 2 start up modes.
a. Use Current Coordinates
Base uses approximate WGS-84 coordinates of current location as base
coordinates.
b. Input Base Coordinates
User specified base coordinates: the specified base coordinates cannot be far
away from the precise WGS-84 coordinates of the current location, otherwise
the base cannot work.
3.2.3 Installation of Rover
After the installation of base, start to install rovers.
（1）Fix the bracket on the pole, fix the handheld to the bracket and then
install the rover on the pole.
（2）Attach the internal radio antenna or connect the external radio
according to the chosen data link.
（3）Power on the receiver and select rover mode.
To Next Page
Loading...
