Preparation
Instructions for use • S-PILOT
®
• PYB194_EN_V1.0_02-2021_IFU_CE-MDR 20
5 Preparation
5.1 Unpacking the product
1. Carefully remove the product and accessories from the packaging.
2. Check the delivery for missing items and evidence of shipping damage.
3. In the case of damage, hidden defects, and short deliveries, document their nature and
extent and contact the manufacturer or supplier immediately.
4. Keep packaging for further transport.
5.2 Testing the product
1. Inspect the product for visible contamination. Do not use if contaminated.
2. Inspect the product for the following characteristics:
– Good working order
– Functionality
– Correct assembly of the components
– Completeness
5.3 Setting up the product
This product and connected components may only be used in medical rooms with electrical
installations that conform to applicable national regulations.
1. Set the product on a horizontal, flat surface. Make sure that the power cord can be
unplugged at any time.
2. Install the product out of reach of patients.
3. Ensure adequate air circulation.
5.4 Connecting the product
1. Connect the potential equipotential cable.
To Next Page
Loading...
