Storz S-PILOT - S-PILOT with AUTOCON III 400

Preparation
Instructions for use • S-PILOT
®
• PYB194_EN_V1.0_02-2021_IFU_CE-MDR 25
ð The tube squeeze valve remains opens for as long as the activation signal is present (plus
shut-off delay of 3seconds).
5.9.4
S-PILOT
®
with AUTOCON
®
III 400
1. Connect AUTOCON
®
III 400 to the power supply.
2. Switch on AUTOCON
®
II 400 and wait until the boot sequence is complete.
3. Connect S-PILOT
®
to the power supply.
4. Attach AUTOCON
®
II 400 and S-PILOT
®
to the connecting cable (UP004) on the remote
control socket concerned.
5. Switch on S-PILOT
®
and wait until the boot sequence is complete.
6. Activate the HF device.
ð The tube squeeze valve remains opens for as long as the activation signal is present (plus
shut-off delay of 3seconds).