Stratasys Objet500 - Off-Line Mode

Objet500 User Guide 5 Using Objet Studio
DOC-07027 Rev.E 5-86
3. EnterthecomputernameoritsIPaddress,orclickBrowsetofindand
selectit.
Figure5-106Connectingtoaprinter(B)
4. ClickOK.
Whentheconnectionisestablished,ObjetStudioisconfiguredtoprepare
printjobsforthatprinter.
Ifyoucanseethemateriallevelsinthe"JobManagerScreen"(seeFigure
5-104onpage5-83),ObjetStudioisconnectedtotheprinter.
Normally,thereshouldbenoreasontochangetheprinterconnection.
Occasionally,however,youmayneedtoresettheconnection,toconnectthe
servertoanotherprinter,ortouseObjetStudioinoff-linemode(withouta
printerconnection).
Note:Aprintercanbelistedbyitsnameorbyitscomputer'sIPaddress.
Off-line Mode
YoucanuseObjetStudiotopreparetraysforprintinginoff-linemode,ona
remotecomputerorwhentheprinterconnectionisnotavailable.Youalso
useoff-linemodetopreparetraysforprintingwithotherprinters.Inthis
case,ifObjetStudioiscurrentlyconnectedtoaprinter,youmustchangeto
off-linemodebyremovingthisconnection.