Stratasys Objet500 - Printing Indicators

To Next Page

To Previous Page

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter

DOC-07027 Rev.E 6-9

Printing

Indicators

Theprinterinterfacescreenchangeswhenyousendaprintjobtotheprinter

(fromObjetStudio),iftheprinterison line:

•ThemodechangesfromPre-printtoPrinting.

•Thespecificactivitybeingperformedisshowninthe“currentactivity”

field.

•Currentjob-printinginformationisdisplayed.

•Theprintingprogressbarisdisplayed.

•TheStopandPausebuttonsareenabled.

Whentheweightofacartridgedropsbelow100grams,thedisplayofthe

materiallevelintheprinterinterfaceisred.

Figure6-5Printerinterfaceduringprinting