Stratasys Objet500 - Starting the Printer

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-3
Figure6-1TheObjet5003DPrinter
Starting the Printer
Caution
l DonotattempttooperatetheprinterbeforebeingtrainedbyaStratasys
CustomerSupportrepresentative.
l Observeallsafetywarningsandfollowthesafetyguidelinesdescribedin
Chapter2.
1. Turnonthemainpowerswitch,locatedatthebackoftheprinter.
Figure6-2Mainpowerswitchandcable