Stratasys Objet500 - Page 183

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-52
5. Inthefollowingscreen,selectContinuewithHeadoptimizationifyouhave
recentlycleanedtheprintheads.Otherwise,cancelthewizardandrunthe
HeadCleaningwizard.
Figure6-67Cleanprintheadsscreen
6. Inthefollowingscreen,selectReplacefaultyheads,andclickNext.
Figure6-68Procedureselectionscreen
PreparingthePrintBlock
7. Selecttheprinthead(s)needingreplacement,andclickNext.
Figure6-69Headselectionscreen