4
Your set-top box has been manufactured to meet international safety standards, but you must
take care to operate it safely.
It is important that you read these safety instructions.
WARNING
Remember that contact with AC mains can be lethal or can cause severe electric shock. To avoid
the risk of electric shock:
Never attempt to open the plug-mounted power supply. There are no user-serviceable
parts inside it, but there are some high-voltage live parts.
Make sure all electrical connections are properly made.
Do not connect any equipment to the mains supply until you have properly connected
all the other leads.
Disconnect the plug-mounted power supply from the mains wall socket before you
disconnect any equipment from your set-top box.
Never push anything into holes, slots or other openings in the case (except a smartcard
into the slot provided, and only when you are requested to do so).
CAUTION
Do not use or store your set-top box in hot, cold, damp or dusty places.
Do not block the ventilation holes of your set-top box. Leave a gap of at least 5cm
above and around it to allow for adequate ventilation. Never stand it on soft
furnishings.
Do not put anything on your set-top box which might drip or spill into it. Never stand
objects filled with liquids, such as vases, on top of your set-top box.
Do not place your set-top box in an unventilated cabinet or on top of a unit which emits
heat (e.g. a VCR).
Never place naked flame sources, such as lighted candles, on top of your set-top box.
Your set-top box itself is designed for use only with the 236-0618010 plug-mounted power supply.
On the plug-mounted power supply there is a label which specifies the correct mains supply input
for it. Do not connect the plug-mounted power supply to any supply other than this.
Always connect the 6 Volt lead to your set-top box before you insert the plug-mounted power
supply into the mains supply.
To disconnect power from your set-top box, always remove the plug-mounted power supply from
the mains socket-outlet (i.e. not by removing the 6 Volt lead from your set-top box). Therefore you
must install your set-top box near to the mains socket-outlet, which should be easily accessible.
If you are in any doubt about the plug-mounted power supply, its lead or its connection, consult
a competent electrician.
Please follow the instructions in the following sections, which guide you through connecting and
setting it up.
See also page 11 and page 12, which describe your set-top box’s remote control.
USING EQUIPMENT SAFELY
CONNECTING TO THE MAINS SUPPLY
IMPORTANT
To Next Page
Loading...
