Strong SRT 4922A - Antenna Setup

13
English
6. Operation
6.1
Getting Started
➋
Antenna Setup
1. Press the MENU button to display the main menu.
2. Use and to move in the menu.
3. Press OK on ‘Dish Setting’. The following window will appear. <Figure 6.1.2>
If you have a motorized dish, press OK on ‘Motorized Setting’. < Figure 6.1.3>
✽ Note: Enter a 4-Digit password if need arise. The default password is ‘0000’.
4. Select the item that you want to edit, and set its parameters as desired. <Dish Setting>
▪ LNB Power: Select among ON/OFF/13V/18V.
▪ LNB Type: Select among Single/Universal/OCS/SaTCR.
▪ LNB Freq: Set the frequency of the LNB oscillator.
▪ 22KHz: When not AUTO, set the signal path from LNB or switch by selecting a control signal
among 0/22KHz.
▪ DiSEqC 1.0: Select DiSEqC 1.0 Port
▪ DiSEqC 1.1: Select DiSEqC 1.1 Port
5. Select the item that you want to edit and set its parameters as desired. <Motorized Setting>
▪ Frequency: If the default TP frequency is not appropriate, you can select another
TP frequency at which to check for signal.
▪ DiSEqC Motor: Select DiSEqC protocol among OFF/1.2/USALS as appropriate for your Motor.
Figure 6.1.2 Figure 6.1.3
[2013.01.04]SRT4922A 매뉴얼_english_AUS.indd 13 2013-01-04 오후 4:49:45