25
6.1 Getting Started
▣ Package Identifier (PID) Scan <Figure 6.1.12>
1. Select a transponder.
2. To change a transponder’s information (Frequency, Symbol Rate),
use the NUMERIC buttons.
3. To add a new transponder, press the GREEN button.
4. To delete a transponder, press the YELLOW button with the cursor
next to the Frequency parameter.
5. To search a transponder, set its different
parameters and press You can search a specific channel
of the transponder by setting its PID data (Video, Audio and PCR).
Figure 6.1.11 Figure 6.1.12
✽ Note: If you cannot access programs after correctly
completing a scan procedure, please contact your seller or your
installer.
▣ OTA Menu 1. Scan Mode ▪ Default: OTA service by default
setting ▪ User: OTA service by user’s setting 2. Select a
satellite for OTA service (Available only when Scan Mode sets
as User’s mode) 3. Enter the transpondes’s information
(frequency, symbolrate)by 0~9 buttons. (Available only when
Scan Mode sets as User’s mode) 4. Press RED button to start
Scan. 5. If transponder’s information is correct, a pop-up
window will display to update software.
To Next Page
Loading...
