Strong SRT 4922B+ - 7 Troubleshooting

78
7.Troubleshooting
Problem Possible causes Remedy
The LED light on the
front panel does not
light
The AC power cord is
disconnected.
Connect the power cord
properly into the power
socket.
No Picture or sound
Wrong connection of the
video/audio output to the TV
input terminal. Wrong
connection of the satellite
antenna cable. Wrong
direction of the satellite
antenna. No signal or weak
signal. Wrong setting of
channel information in the
MENU screen.
Connect the two terminals
correctly with RCA or HDMI
cable(s). Connect the antenna
cable correctly. Adjust the
direction of the antenna.
Check the cable connections,
the LNB and other equipment
connected between the LNB and
the receiver, or adjust the
antenna. Type the setting
values correctly.
Black-and-
w
hite
screen or V-Hold
Your TV mode (PAL/NTSC) is
different from the
satellite broadcasting
mode.
Use a TV of the same mode.
Connect a NTSC/PAL converter
between the receiver and the
TV.
The remote controller
Batteries are exhausted. Change the batteries.
is not working
Fluorescent light is
interfering with the remote
controller. Remote
controller is incorrectly
aimed.
Switch off the light. Aim the
remote control at the
receiver.