Strong SRT 4922B+ - Page 52

52
▪ If a future time (next) EPG is selected, the selected program will
be reserved and the event color will change.
5. You can select TV or Radio channels by pressing the TV/RADIO
button
6. You can choose a channel list group by pressing the GROUP button.
7. You can access the timer menu by pressing the RED button. <Figure
6.4.2>
8. You can choose a EPG mode by INFO button
➋ Timer
This sub menu allows you to set the on/off time of your receiver.
1. This submenu allows you to set on/off times of your receiver.
To display the timer menu, press the RED button while in the guide
menu. <Figure 6.4.2>
2. Press OK to select a timer’s parameter.
3. Press
to change the parameter.
▪ Timer No: Select the timer that you want to modify. (1- 32 )
▪ State: Select the timer frequency. (off/once/daily/Mon~Fri/weekly)
▪ Date: Press OK to display a Calendar pop-up; Select a date
▪ Start Time: Input the time for your receiver power-on; use the NUMERIC
buttons
▪ End Time: Input the time for your receiver power-off; use the NUMERIC
buttons
▪ Channel: Press OK to display a Channel list pop-up; Select a channel
▪ File Name: Press OK and enter file name using keypad.
▪ Record: Set the record mode (ON/OFF)by using the left and right arrow
button.
▪ Power Off: Select Power Off should you wish the receiver to turn to
standby after recording has finished.
6.4 Electronic Program Guide