Although you have ‘Auto Scanned’ your receiver to
lock in available frequencies in your location, it is also
possible to initiate a Manual Scan. This enables the
possibility of scanning and locking in a channel that
may not have been selected by the auto scan.
• Push the MENU Button, and Welcome Banner
will appear.
• Push the BLUE Button for Main Menu.
• Banner at the top of the TV screen will be viewed
listing: Installation / Set Up / Information.
• Scroll to & select Set Up by pushing OK Button and
4 topics will appear.
• Scroll down to Scan banner & push OK and 3
menus will be viewed.
• Select Scan Channel and push OK, Scan Channel
Banner will now be viewed.
At the bottom of the banner you will see a Green Icon
for Frequency (Freq)
• Push Green (Freq) button and frequency sector in
the banner will be highlighted.
• Enter the Frequency number you are searching for
via the remote controls numeric buttons.
• Scroll down to OK to Scan and push OK.
• With the Channel now found, Tuning OK banner
will be viewed.
• Push OK to confirm.
• Push Exit 3 times to return to normal TV broadcast.
36
Manual Scan
To Next Page
Loading...
Need help?
General
