Symptoms
LED on front panel does
not light up
No Picture & Sound
Picture and/or Audio Glitch
No Sound
Remote Control not working
Solution
Check the main power cord is
plugged into the wall outlet and
check that the power connector of
the unit is plugged in.
Check your TV has been set to
correct AV Mode.
Check you selected connections:
Scart / S-Video / RCA / RF / Ant.
Check Signal Level & Quality level
indicators of the Receiver to verity
whether your antenna signal is
adequate.
Check all antenna cabling used is
Quad Shielded type, including the
antenna Fly Lead from the wall
socket to the receiver.
Press the MUTE button on the
remote control of your receiver
and TV.
Set your desired TV volume level
via TV remote control.
• Insert batteries
• Change batteries
• Aim at the receiver
Troubleshooting
There may be various reasons for abnormal operation
of the unit.
Occasionally receivers can hang-up (just like a PC).
In this circumstance, it is recommended to reset the
receiver by disconnecting if from mains power.
Wait 30 seconds and connect to mains power again
and check if receiver is working correctly.
If there is still incorrect operation, please refer to the
following table for the indicated problem.
39
Possible Cause
AC power is disconnected
TV Mode is Incorrect
Problem in cable connections
between receiver & TV
Insufficient Signal Strength
for Digital
Electrical Interference
The receiver or the TV
is in MUTE mode
Initial Volume Level has not been
set on your TV
• Batteries not inserted
• Batteries exhausted
• Outside range of operation
To Next Page
Loading...
Need help?
General
