Basic Operation
Firmware Update
Upgrade software by inserting USB device into the USB port.
Please visit the Software Updates section of the STRONG website at
http://www.strong.com.au/software.html to download the latest software version for
the SRT 6500.
Once you have downloaded the software place it on a USB stick, please ensure that
the USB stick has no other files stored on it other than the required software file.
Then click on the “How to Install” link for a complete step by step instruction sheet on
how to update your receiver to the latest software version.
Factory Default
Use this option if you encounter a problem after having changed some parameters.
This option will reset the unit’s data to restore it to the factory default settings.
1. Press [MENU] to open MAIN MENU.
2. Press [UP]/[DOWN] to select “Setting”
3. Press [OK] /[▶] to select “Factory Default”.
4. Press [OK] and enter password to confirm.
NOTE: Factory default password is “0000”.
Parental Control
1. Press [MENU] to open MAIN MENU.
2. Press [UP]/[DOWN] to select “Settings”
3. Press [OK] /[▶] to select “Parental Control”.
4. Press [OK] and enter password to confirm (Default password is “0000”)
There are 8 levels available in “Censorship”. Press [UP]/[DOWN] to select the rating
level.
ALL BLOCK: All programs are blocked.
P: Pre-School
C: Children
G: General.
PG: Parental guidance.
M: Mature audience, 15+ year old.
MA: Mature adult audience 15+ year old.
R: Restricted, 18+ year old.
AV: Adult audience, strong violence, 15+ year old.
NOTE: Once censorship level has been selected you will need to enter a PIN number
to view channels or access menus that have been locked.
To Next Page
Loading...
