Strong SRT 7010 - Page 22

18
the scan process has been completed, all found channels will be stored and
the receiver will switch to the rst found channel.
Multi-Transponder Scan:
Select the transponders you want to scan with the OK button. The selected
transponders will be marked with the z symbol. Press BLUE for Scan. A
window with scan settings will be displayed. After conguring the settings
like explained in 7.3.1.2 above, press OK or BLUE again to start Multi-Scan on
all selected transponders.
7.3.1.5 Satellite Edit options
Add satellites: Press RED to add a new satellite. In the pop-up banner, enter the satellite's
name and position by using the p/q tu and 0 ~ 9 buttons.
Satellite Name: Press OK to enter text input mode. In the key table select a character by using
the navigation buttons. Press OK to enter the chosen character. When you
have entered the name, navigate to the “OK” button on screen and press OK
on the remote control to conrm the new name. Save the settings with OK or
cancel by .
Edit satellites: Press GREEN to edit the focused satellite. For changing settings see
explanation above. Conrm changes with OK or cancel by .
Delete satellite: Press YELLOW to delete the focused satellite. Press OK to conrm deleting or
 to cancel.
7.3.1.6 Transponder Edit options
Note: Transponders can only be edited when the transponder list is on screen. To
do this, select the satellite you want to edit and press 4 to open the TP list.
The options below are now available.
Add transponder: Press RED to add a new transponder. In the pop-up banner, enter the
transponder´s data by using the p/q tu and 0 ~ 9 buttons. Conrm the
settings with OK or cancel with . An existing TP cannot be stored again
under the same satellite.
Edit transponder: Press GREEN to edit the highlighted transponder. In the pop-up banner,
change the transponder´s data by using the navigation and numeric buttons.
Conrm changes with OK or cancel with .
Delete transponder: Press YELLOW to delete the highlighted transponder. Press OK to conrm or
 to cancel.